Re: GOT IT WORKING!!!!!!


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Just Michael on January 06, 2002 at 15:18:50:

In Reply to: Re: GOT IT WORKING!!!!!! posted by JIMI on January 06, 2002 at 09:34:48:

I have a dumb question:
If the arcade monitor works good with your ATI card, why don't you use it instead of the Creative card?

I went to Creative's site and this is what they had to say about the TVCoder:
Creative TVCoder is a cost effective VGA-to-Video signal decoder system for low cost color video output. Creative TVCoder converts text, graphics and animations from the PC into video signal for output on regular TV or for recording onto VCR.

From this I am guessing the output of the TVCoder was meant to go to a television. You would need something to process the signal back into something a monitor could use. If yours has a scart output, I do remember reading about a conversion from scart to arcade monitor but I have no idea where the page is.

: : : Jimi,
: : : I got my monitor working tonight. I was having the excat same problem you were having with the scrolling monitor. I re-stripped my wire ends and made sure they were all conected cleanly. I'd sugest you do the same and see what happens. Thanks to RandyT for sugesting this to me. Hope this helps you.

: : : ~ Chazz

: : Thanks but meaby You not read well my message..
: : My wires , my cable ,my monitor ...all...is perfect! My monitor NOT rolling IF I connect the PC on DOS...MY monitor ROLL only when I connect the ADAPTER CREATIVE..on the RGB port...the picture are GOOD but the Roll non stopped!
: : For this I ask a help..I need a EXTRA connect/circuit for have again the right syncro!
: : :
: : : : Excuse my BAD english...
: : : : I'have this problem:
: : : : My ArcMon (Hantarex) work good with AOS (DOS)+mame on my SVGA card (ATI).
: : : : Well ...I have also a little Adapter (CREATIVE TVCODER EXTERNAL 6011) with 3 output , 1) TV s-video 2) StandarVGA 3) RGB output....
: : : : well the n.3 have the right functions for connect the monitor arcade , and see windows (640x480) 16 or 32 bit colors!...the picture is nice.but..yes ONLY one BIG problem! The picture roll all the time , and is impossible to adjust fine the trimmer on the back-monitor , because You never found a good regolation!!! So , The syncronism have a problem when I connect This CREATIVE adapter, My question...ANYONE know waht can I do , meaby with a extra little circuit for STOPPED this STUPID ROLLING effect?!?

: : : : THANKS!!





Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link address (start with http://):
Link Title:
Optional Image address (start with http://):


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]