Re: Screwing into MDF on the edge


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Matt on February 13, 2002 at 19:25:37:

In Reply to: Screwing into MDF on the edge posted by Jonathan the Red on February 13, 2002 at 17:53:57:

: There's lots of great info from knowledgeable people in the materials thread. Two guys (Matt and RandyT), both of whom really sound what they're talking about, advise against driving screws into MDF on the edge.

: This concerns me a great deal because that's exactly what I was planning on doing for the fixed portion of my control panel. As you can see in this picture (warning: 330K jpg), I wanted to screw it into the edges of the boards that make up the sides of the control box.

: I definitely don't want to split the MDF (those particular pieces are just 1/2" thick), but I'm way past the point where I can disassemble the box. And the screw holes (in the proper places) are already drilled in both the fixed panel and the Lexan. Moving them isn't really feasible at this point either.

: The screws don't need to be particularly sturdy. They're just intended to hold the panel in place and they don't need to bear any load. Can anyone advise (especially Matt and/or Randy) about just how risky it'll be to drive those screws in? And if I choose to go for it, what's the best (and safest) way to predrill to minimize the risk?

: Thanks in advance.





Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link address (start with http://):
Link Title:
Optional Image address (start with http://):


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]