Re: Question to Matt -- Laminating and T-moulding


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by PCC on February 15, 2002 at 10:12:32:

In Reply to: Re: Question to Matt -- Laminating and T-moulding posted by aramis on February 15, 2002 at 09:28:33:

You can get the plastic T-Molding and Slot Cutter at Rockler.com
http://www.rockler.com/findit.cfm?page=1181

Use 13/16'' molding for laminated sheet goods (requires a slot cutter with a 5/64'' kerf)

: I can't remember the url, but there is a place online that offers t-molding for use with laminate. It is slightly wider, and has the vane offset a bit, so that you still center your groove on the mdf (or whatever), and the extra offset width hides the edge of the laminate.




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link address (start with http://):
Link Title:
Optional Image address (start with http://):


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]