Re: Any good ways to attach drinkholders?

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by NipsMG on March 06, 2002 at 18:46:01:

In Reply to: Any good ways to attach drinkholders? posted by lightspeed on March 06, 2002 at 17:38:54:

: This is essential to my project, but I can't figure out how to really do it without ruining the finish on the sides.... any suggestions?

Well, this will ruin the finish but.... :)

I installed cupholders (well BEERCAN holders) IN my panel.. I drilled 2 holes just larger than beercans, then used PVC PipeEnds with the screw on bottoms and superglued them underneath the holes.. Worked like a charm :) (And the cans were low enough into the panel that the beer didn't spill! :))


-- NipsMG


Follow Ups:


Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link address (start with http://):
Link Title:
Optional Image address (start with http://):

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]